Page 1 of 1

Brush Making Tutorial still current?

PostPosted: 26 Jan 2014, 22:11
by ghmd
Hello,

I just followed this tutorial: viewtopic.php?f=18&t=42.

However, no matter what I do, the brush does not look like the one in the tutorial - even though I followed the instructions to the letter!

Instead, when changing the color parameters in the last part, I do not even have colors at all.


I do not understand it.

Is it possible that since this tutorial has been written, updates where made that changed the initial settings?

Re: Brush Making Tutorial still current?

PostPosted: 27 Jan 2014, 14:11
by u2bleank
ghmd : you're right ! The problem come from the Speed parameter which react differently from the time this tutorial was made.
Try to use the Mul Parameter just after the Speed Block and change the value from 5.0 to 30.

Re: Brush Making Tutorial still current?

PostPosted: 29 Jan 2014, 17:51
by clayton
Can you say what specifically has changed with regards to the Speed node ?

Is it likely to change again in future updates ?

Also: Have you changed any other node behaviours ?



Regards,

Clayton

Re: Brush Making Tutorial still current?

PostPosted: 31 Jan 2014, 09:10
by u2bleank
Can you say what specifically has changed with regards to the Speed node ?


as stated here :
The way the Speed is computed from stroking has changed. It’s now more accurate and reflect better the dynamic. "Warning if you have created some of which use speed, their look could have changed."

Is it likely to change again in future updates ?


I hope not :reyes:

Also: Have you changed any other node behaviours ?


No. We try to stay more stable as possible but it was a rare case where we have to change.