Page 1 of 1

Brush flow

PostPosted: 22 May 2019, 11:40
by tanuki
I'm banging around in the brushes and I'm a bit stumped with how to do a few things (still in a bit of a photoshop mindset for brushes)

In photoshop I have a simple flow slider from 0-100% where I can adjust the flow of the brush. What is the equivalent of this in BI? I can't seem to figure it out. :?:
My most basic brush is a simple hard brush with flow at 50% and transfer set to pen pressure. I'm at a bit of a loss how to recreate this in BI.

Re: Brush flow

PostPosted: 23 May 2019, 09:25
by bonnie
Hi!

If you want to modify the flow of your brush you go to the Flow tab and modify the Shape interval value

Image


You can even go up to 400%.
Then if you want something more precise you can unfold the parameter and you will load a control.
For example, I take the pressure smooth but there are quite a few others.

Image

If you open the controllers panel ([C] or Window > ControllerEditor) you will see the nodes connected to your parameter

Image

Now your controller icon is active.
You can change your values with a minimum / maximum range

Image

And of course once you have done your brush you can save it by going to the brush manager ([M] or Window > Brush Manager)

Image

Don't hesitate to share your creations with us :happy: